Jump to content

Iridium flare ερωτηση.


Προτεινόμενες αναρτήσεις

Σημερα η εφαρμογη για Android, "Heavens Above" οπως και αλλες εφαρμογες για iridium flares, ελεγαν οτι στην περιοχη μου ενα πολυ λαμπρο iridium flare θα εμφανιστει, το Iridium 53 με λαμπροτητα -8.3 (magnitude).

 

Μια αλλη εφαρμογη για Android το SkySafari 5 Pro ομως, παροτι ελεγε και αυτο οτι το Iridium 53 θα περασει απο το σημειο στον ουρανο οπου και το "Heavens Above" και αλλες εφαρμογες ελεγαν οτι θα περασει (και θα δωσει την "λαμψη") και την ιδια ωρα και επισης ελεγε οτι θα εχει λαμπροτητα -8.2 επισης, ελεγε οτι το φαινομενο ολο θα ειναι ΜΗ ορατο.

 

Τελικως το φαινομενο(iridium flare) ηταν πραγματι μη ορατο και τιποτα δεν εμφανιστηκε στον ουρανο σε εκεινο το σημειο εκεινη την ωρα.

Ο ηλιος στην περιοχη μου εδυσε στις 19:21 και το πολιτικο λυκοφως εληγε στις 19:48 ενω η "λαμψη" αναμενονταν στις 19:43:40" εως 19:43:45" περιπου.

 

Οποτε οι ερωτησεις μου ειναι:

α)Γιατι το iridium flare δεν εμφανιστηκε? (Ο ηλιος ειχε δυσει θυμιζω) Επειδη ημασταν σε πολιτικο λυκοφως? Η λαμψη ομως που αναμενονταν ηταν -8.2 και επρεπε να εμφανιστει αφου ηταν αρκετα σκοταδι. Ετσι και αλλιως αστερες με λαμπροτητα +0.1 ηταν εμφανεις.

 

β)Πως το SkySafari 5 ηξερε οτι θα ειναι μη ορατο? Την ιδια στιγμη που οταν "ετρεχα" την ωρα μπροστα στις 19:43:42" περιπου, ελεγε οτι η λαμπροτητα του Iridium 53 ειναι -8.2.

 

 

(Η περιοχη μου ειναι περιπου 40.65Ν, 23.0Ε)

Σύνδεσμος για σχόλιο
Κοινή χρήση σε άλλους ιστότοπους

Απαντήσεις όπως ακριβώς είναι διατυπωμένες στο heavens-above.

Ισχύουν όλα.... επιπρόσθετα και μάλλον αναφέρομαι για την έκλαμψη που προανέφερες ήταν ορατή αλλά την είδα την τελευταία στιγμή κοντά στο ζενιθ σε διαφορετική δηλαδή από την προβλεπόμενη θέση και ήταν πολύ εντυπωσιακή.

 

 

 

 

I saw a predicted flare, but it wasn't as bright as I was expecting. Why not?

 

The predictions we make assume that the Iridium satellites have exactly the nominal attitude (orientation). However, the onboard control system maintains the attitude only to within about 0.1° of the nominal, and this unpredictable difference can lead to the actual intensity of a flare being significantly lower (or sometimes higher) than predicted.

 

Also, please make sure you've entered your coordinates as accurately as possible.

 

 

 

 

The flare I went out to see didn't appear. What was the reason?

 

Sometimes, but not often, flares fail to appear completely. There are several possible reasons;

 

The satellite could have recently failed, and its attitude is no longer tightly controlled. Several Iridium satellites have failed since they were put into orbit and are no longer in either the nominal attitude or orbit. As soon as we know that a satellite has failed we remove it from our predictions, but one that has only recently failed may still be flagged as operational and erroneous predictions will be in our list.

The satellite could be temporarily in a non-nominal attitude. This can happen, especially shortly after launch, when a satellite is being checked out, or maneuvering. If it isn't in the expected attitude, the chances are the flare will not appear since the geometry between sun, satellite and observer is so critical to a flare appearing as predicted.

You could have been looking in the wrong direction! Please make sure you understand what the azimuth and elevation angles mean in the predictions table, and don't confuse the direction to the flare centre which is shown on the small map of the flare details page with the azimuth of the flare which is the direction you should be looking.

You could have been looking at the wrong time. An Iridium flare only lasts for a few seconds, and if your watch is not set accurately, or you look away even for a few seconds, you could miss it. You can use our "What time is it?" page to get an accurate time.

Your coordinates or time zone could be entered incorrectly. Please make sure that you have entered the correct coordinates for your location. Iridium flares are especially sensitive to position errors, and you should try to enter your coordinates to 1km (about 0.01°) accuracy if you can. Also check that your time zone is correct. You can do this by comparing the local time given on our "What time is it?" page with the current time at you location.

Σύνδεσμος για σχόλιο
Κοινή χρήση σε άλλους ιστότοπους

Δημιουργήστε έναν λογαριασμό ή συνδεθείτε για να σχολιάσετε

Πρέπει να είσαι μέλος για να αφήσεις ένα σχόλιο

Δημιουργία λογαριασμού

Εγγραφείτε για έναν νέο λογαριασμό στην κοινότητά μας. Είναι εύκολο!.

Εγγραφή νέου λογαριασμού

Συνδεθείτε

Έχετε ήδη λογαριασμό? Συνδεθείτε εδώ.

Συνδεθείτε τώρα
×
×
  • Δημιουργία νέου...

Σημαντικές πληροφορίες

Όροι χρήσης